I am still to lazy to put the pictures in story order.
Yesterday I cut some 3" wide strips from nice plywood. two of them 3/4" and one 1/2". Then I cut in a bit to go under the angle.
Today I cut a 5.5 degree angle on the wood to make a nice slope. It taxed my table saw a bit because I had a fine tooth blade in there and cutting the full three inch height. I but each board and took a break before cutting the next one to have a 50% duty cycle.
I am finding lots of things funny lately.
This was the intention. But by happenstance the cutoff of the middle row was perfect for use as the thinnest section.
While I would have liked to use a vacuum bag to glue this down I used glue and nails. Then put weight on the thinnest part so it will have good adhesion to the base plywood.
Tuesday, February 06, 2024
Subscribe to:
Post Comments (Atom)

.jpg)





No comments:
Post a Comment