In the process of making a limo
The bench got a coat of oil.
I also rearranged the shop to get these two train cars ready to bring out to the track for storage. That would free up eight square feet in my shop.
With the help of the extension I could drill clearance holes for the vise screws. If I had planned ahead the bench would be two inches wider it would be much easier to install the vise.
A while back in a state of productive procrastination I cleaned up this corner of the shop. Moved all the stuff out, vacuumed and put the stuff back.
The vise is made of oak, same as the rest of the bench.
I found some very pretty wood at the side of the road. I have a plan for this wood.
To drill the vise screw clearance hole in the leg I had to add in some temporary wood, I tried pine first but the drill bit drifted into the soft wood so I had to redo with oak scraps.
The vise clearance hole is 3/4" in the leg, the rest is in the air.
The tops are bolted to the legs.
Some of the o scale club
I used a diablo 1-3/8 bit to drill the hole. the screw at the front makes it VERY aggressive.
The vise in place, it is glued in place... the top is bolted on... well at least the vise is not glued to both the top and legs. I never plan to take the top off the legs.
I made a quick frame for under the gondola. This is so it can be parked on storage rails.
The bench with one and no layer of oil.
Adding corner braces being installed.
There are two standard sized of box car siding.
Looking at the bench back upright.
Finished diagonal brace. There are one in each corner. They were not fun to install, I did not do great at tight joints.
This boxcar is a future project.
This is an underside view of the top holding bolts.
I want to have the vise gears blued over silver. I will use the heat an linseed oil method.
This is how far in the vise screws go in in the closed position I could have had more overhang.
To sand all the surfaces, and to install some braces on the bottom to allow it to be lifted with the lift the table went upside down.
Then onto sides for epoxy to fill the cracks and holes.
Puff Puff Puff Puff Puff
The underside of the O scale modules.










.jpg)

















.jpg)
No comments:
Post a Comment