A few shots of the electronics bay at the start of today's work. I have been taking some pictures but have posted on 7-8th.info instead of in blog posts. Today is a jumble of past work uploaded to keep things all here for reference.
The power connector is mounted to the side wall, next is a terminal strip for the speaker / amplifier. The last thing on the side wall is the LED driver. It is powered at 5v, Robb says this is OK but it states 9v-30v input.
The white box holds the switches, inside is for MU and 9DoF (the terminal strip is for that purpose also. On the outside is the 24V circuit breaker I think the same 30A one, or one from a razor scooter. Then the power switch, from a razor scooter. The three switches are the radio / onboard choice switch, then the grandpa switch, then head end direction choice. Last is a volume pot.
Through the battery tray, a tight fit to with the onboard controls.
When I made the hole into the electronics bay I used sheets of paper and tape, lots of tape, to protect the electronics from the metal dust. I used a die grinding bit in the dremel to do the work and vacuumed often. I plan to use some putty to seal the openings as there is a small chance of water intrusion.
This is the tray to hold the RX box, it goes above the sabertooth, it has magnets in the feet to hold it in place. Other than the antenna wire all the other wires will be long enough to allow moving enough to access the sabertooth and sound card for reprogramming.
A couple pictures of my 7/8ths info group swap. From Bill Martensen I received a series of crates. The new lever for the SBT. This one has a magnetic catch at the pivot but is held to the cable with a pinned lock block. This was made before I decided to permanently apply the person.
Forward and reverse with the lever.
My practice carving shoes, I don't think any of them are right... so I made one more that was for the right foot.
Soon I will be gouging out the top of this shoe for the wires.
I took a break from the SBT to make button coasters.
The sander kept throwing the drive belt, Lilli and I tried wondered if we could fix it.
The final 47 before finish application. 3 Pine, 8 Plywood, 8 Oak, 13 Mango, 11 Walnut if I remember correctly.
Back in time to before the switch cover was applied.
This shows where I plan to keep the log, I will need to have a support toolbox as there is no battery charger onboard. I do not own a charger yet that will work. At this point the 9DoF will also be a separate box that plugs into the SBT. I think it may be a tool I will want to use on other locomotives.
Remaining items to do:
Double check all wiring installed, confirm no shorts or breaks.
Hook up signal wires to the wav trigger.
Install the RX and hook up the wires.
Program the wav trigger.
Program the sabertooth.
Test the basic setup.
Make the 9DoF box.
Program the 9DoF.
Make correct sounds.
Apply driver to seat.
Make triggers in the driver.
Show off.
No comments:
Post a Comment