Wednesday, September 06, 2017

New Railcar

 I spent a bit of time cleaning up the shop and I saw the returned Digitrax throttle that one of the buttons would stuck down.
 I was able to open up the hole in the case and reassemble, now it physically works but I do not know if it electronically works.
 I really like this car, it was at MCRR this weekend for the op session.
 Eventually I will build a few wood box cars.  One will be for barrel works.
 Joe having fun with his new mogul


 The underside of a couple of Tom's cars

 And my hopper behind Dick's.  Dick thought I was going good on the hopper, but I should change the trucks.
 Then it was time to switch with the Scott & Adam.
 Adam was learning his newly rebuilt 10 wheeler.
 Back home I decided to make a new railcar for my railroad.
 Drill a pilot.
 Check the center to center location and adjust as needed.
 Drill a larger pilot
 and have a centered hole.
 Then I made a jig to add safety chains to a Madee K frame.
 I used the same jig to add body mounting bolts.
 Conditions of assembly met
 Drilling for the safety chains

 The first body bolt
 tightened.
 And back to the safety chains, need to open them up
 Twist to the side not radially, it goes much easier.





 Nancy showing my fix so I can attach to the closed hook, file the wide spot a titch so it will go through the chain.
 Use two nuts to attach.



Done, Jon now has a new railcar.  I may have to play around with loading and springs.

No comments: