Monday, June 06, 2022

Wider

 Today I picked up another red oak board and made the top wider.

The planer blades are dull,  I could only get a 64th off at a time and it was still complaining.  I waited five minutes between passes.

It was not enough, I still had to hand plane the last four inches of the last pass.  Because the motor temp sensor went.
These two pictures show before and after a pass.   Note the snipe at this end.

Remember the snipe... on all the boards ... that adds up to being a 1/8th inch narrower at the ends than in the rest of the glue up.   Ooops.  

No comments: