Wednesday, June 01, 2022

Side Two is Close

 But not close enough.

I have two issues.   The length is off by about 1/8th of an inch.  
The top cross member is 3/16" low at one end.  

It took me a while to figure out that it was not that the second set was out of square and several other issues.  It is only two.  Tomorrow I will cut some off the bottom of the tenon and glue it to the top.  That will move the cross member to the proper place.  Then I will draw everything tight and as I will have just adjusted the angles make a cut on the cheeks of the tenon with a saw.  With the leg as a guide that will make the end of the tenon match up nicely.

Then I can add the tenons to the top of the legs.  And chamfer all the edges like I did on the front legs.  Then I can glue up the rear leg set.

This project is progressing much faster than I thought it would.


No comments: