Monday, March 18, 2024

Brake Car To Compressor Car

I decided to move my compressor for brakes from the rear of a flat to a 4 wheel car.  
This used to be the tender for pipsqeek.  It had a link and pin coupler on one end and the knuckle on the other.  I am going for knuckle on both ends.


I am cutting a 1"x2" hole for a coupler pocket.
I thought about going with a smaller battery, but my pump has a max 11am draw and the medium battery is 11amp max so I would have to use both, which is not much smaller than the large battery that is a dual purpose and better at the amp draw. 
This is the my first attempt at a tom bee style caboose brake setup.  I managed to use several colors of wire, because they were attached to the components I used.   I think I can do better now.

Thursday, March 14, 2024

New Garage Storage

I made some new storage for in the garage and loaded it up with metal.  Four foot deep and 42" tall.  The same dimensions as the 4 shelving units on the other side of the garage.  the middle shelf has some 8 to 10 foot long pieces with a wall shelf supporting them behind the mill and lathe.  I think to get them out I will have to move the mill and lathe.
The lower unit is build from 2.5 sheets of 3/8 plywood.  It is easier ish than cutting a ton of dados to double up the sides.    
After removing the steel from behind the lathe I put the plastic plates there.  
A few pieces of treadmill frames went under the lathe, others went to the side of the road.
The start of making the sides.  I should have used each shelf in its position vs using one shelf to space all the sides.  It worked but would have been easier if I had places shelves as I put the sides in vs all the shelves after.  The spacers are glued and pinned in place.  
The final resting place
The power tools returned to their home position
I matched cut the left and right side of each spacer.  I left the top one long, but not long enough, I only had to remove 1/4" from the last spacer.
I made a second rack with glue and nails with 3/4 ply from that curbies find.  this one will hold my thin oak strips.  I got to find a project for those.  

Sorting

Took a break from making to do some sorting.  
We found a couple HO train storage boxes at curbies this weekend.  

My other curbies find.  We took it apart and trashed a lot of the wood and used the rest on projects.

Flexispot with custom top

The top, waiting for the legs
The top with six legs
The underside.  The wiring, control board and frame are embedded in the top.  I have used it for about 16 hours now and am still surprised by lack of anything bumping my knees.  It is going to spoil me for when I have to go back to the office.
The shop space is opening up
Cletus McFurland using my heating pad.  Or my catboard in the upright position.
The desk at lowest height.
The desk at work with the frame, wires, and control boxes hanging down.  

Monday, March 04, 2024

Desk is done. Red Boxcar.

We choose to get another color paint.  Much browner than what I had before.  Weird how red it looks.  


My desk is ready for use.  Who wants to carry it upstairs.