I made some new storage for in the garage and loaded it up with metal. Four foot deep and 42" tall. The same dimensions as the 4 shelving units on the other side of the garage. the middle shelf has some 8 to 10 foot long pieces with a wall shelf supporting them behind the mill and lathe. I think to get them out I will have to move the mill and lathe.
The lower unit is build from 2.5 sheets of 3/8 plywood. It is easier ish than cutting a ton of dados to double up the sides.
After removing the steel from behind the lathe I put the plastic plates there.
A few pieces of treadmill frames went under the lathe, others went to the side of the road.
The start of making the sides. I should have used each shelf in its position vs using one shelf to space all the sides. It worked but would have been easier if I had places shelves as I put the sides in vs all the shelves after. The spacers are glued and pinned in place.
The final resting place
The power tools returned to their home position
I matched cut the left and right side of each spacer. I left the top one long, but not long enough, I only had to remove 1/4" from the last spacer.
I made a second rack with glue and nails with 3/4 ply from that curbies find. this one will hold my thin oak strips. I got to find a project for those.
Thursday, March 14, 2024
Subscribe to:
Post Comments (Atom)










No comments:
Post a Comment