Sunday, January 13, 2019

Lights

The Lowes by us are closing.  Nancy and I went on the second to last day, we picked up the drip edge, nails and about half the shingles needed.  A few bits of hardware, such as the door stop springs, and a five LED can lights.  The lights were all displays, and I was not paying attention, two had no wires or guts, one had wires and no guts, the last two worked.

 I decided to put them at the bottom of the stairs since the light there keeps burning out.  I figured it might be in the fixture.
Since these were cans for insertion into a ceiling I used a scrap of plywood to hold them.

It does add too much light in this area, maybe later I will move one of them to halfway to my shop.

Also for the steamer.  I did a bunch of figuring what steel I needed and what is available at Alro, and then showed Nancy just to help decide if the cab should be scale 5" or 4" posts.  The answer was 5" and make the cab from wood as that is what the prototypes are made from.

Wednesday, January 09, 2019

Lamp Camp

Nancy finished finishing the base of the lamp.
 I screwed the horn onto the base.
 Attached the cord to the base.

 Installed the touch sensor.
 Attached the wires.
 Attached the cover.
 And then fixed another lamp.

 Take it apart.


 And put it together.

And the lamps work.

Sunday, January 06, 2019

Fixing Hollow Core Bi-fold Door Handle Blowout

More productive procrastination, this time I got tired of how our closet door handles are always loose because the doors have no filler in the middle.

In the case of our pantry door they had drilled two holes for the handle about a half inch apart.  Opening and closing the door had worn the holes so much that they were one and the knob flopped all over.  
The door because of the soft material it is made from, the pull is attached to the back side, it acts like a spring.  The all thread screw then acts like a file, slowly removing material making the handle looser.
 The first step is to remove the door handle and go to the back (inside the closet) side of the door.
Using the hole that is present drill out a larger hole, I used 2-1/8th hole saw.  The MDF is quite soft so go easy drilling.  *see note below.
 With this larger hole we can now see inside the door.  Measure from the back (inside) face of the front panel to the back (outside) face of the back panel.  (Measure the thickness of the door so you know how thick the plug needs to be.
The next step is to make a plug to fill the hole.
 First drill a template with the same holesaw.
 Draw a circle on a scrap of wood the thickness of the door.  This wood is from a pallet, cleaned up on a table saw.  First roughly cut a circle on the band saw.
 Then sand to fit snug in the test hole.
 Back at the door, apply glue to the two flat surfaces.  This will attach the plug to the front panel.
 Push the plug in slightly, spread glue around the edge of the plug to attach it to the back panel.
 Tap the plug home.
Clean up all the glue squeeze out.
 From the front side drill a hole 1/64th larger than the pull knob screw through the plug.
Install the knob, this is the clamp to keep everything tight until the glue dries.  Clean up the sawdust and tools, close the door and admire your handywork.  The door handle will feel oddly solid but you will get used to it in a few days.  Speaking of, 24 hours later come back and remove the knob to touchup the paint.
*This MDF is soft enough to use a utility knife and files to make a square hole and use a square block.  Alternatively purchase closet rod and a hole saw of the same diameter to save the bother of making plugs.