Friday, November 16, 2018

Moved the throttle

I have moved the throttle bar back 5.550 inches from the design position.  This means the throttle rod, page 236 needs to be changed from one 6.5" long to one 12.050" long.  I bought a 1/8" stainless K&S rod but I do not have a split die to thread it.  Robb has a 5-40 die.

I also need to remake part E31 the johnson rod, page 231, while the book says 1/8th mine is .107 thick and 3.825 cl to cl on the holes.  New one needs to be 9.375" cl to cl with the other direction only .300 vs the listed 3/8" 

I have a plan now for the water system, I am going with a linear system again, hand, tender axle, loco axle, bypass valve, boiler.  The bypass will go to the top of the tender as best practice, I will need two quick connects so I can release the loco from the tender. 

I am able to reuse the cab walls, all three pumps and the bypass valve, I will make the two parts above, new cab floor, new cab roof, and new whistle.  Plus the new tender, two new tender bodies (the loco will be 3 unit) new tank, new force sensor MU system. 

My punchlist so far is:
New throttle rod
New Johnson connect rod
Four new floor mounts
Two new cab floors
New cab roof with 4 bar mechanism to swing cab over loco while under steam
New whistle of a Weltyk design Most likely of similar design to this forney.
Buy new plumbing for the water system, decide is water will be connected via quick connect or other union type.
Make a new water tank
Make new body for tender
Make second tender frame (I am hoping Robb will help with that one)
Make second tender body
Buy, assemble and program the force sensor system so I can MU with my other locomotives
Paint / repaint the loco and tenders
Valve for the propane at drivers seat
Quick connects for the propane line from second tender to engine
Toolbox for oils and basic maintenance tools on the tender
Modify the truck deck / make new platform for traveling with the loco

It is tempting to CAD up all the parts I want to make and have them cut for me out of plate, the other option, without a mill is the use of a lot of hacksaw blades and files.

And Nancy asked me tonight if it would be easier to start over with a new loco?  The answer is no, there is plenty of stuff that is good on the loco, making 20 new pieces of trim is a lot easier than making 500 detail parts.

No comments: