Sunday, November 18, 2018

Bars

 Here is a picture of the cab where I was thinking of putting it.  Note about 2.5 inches from the rear of the frame to the rear of the cab.  This was the idea, move the cab back 3 inches to compensate for removing the 3 inch long water tank. 
 Kinda like this.
 
A good plan but I forgot an important thing.  The throttle bar and johnson bar are on a stand that were centered in the window of the cab.  The cab that I was planning to  go rearward 3 inches and the stand that I sent rearward 5.5 inches.  This 1.5 inches makes the levers outside of the cab to the rear.

Yesterday I visited Robb and he made a new bar for the throttle and I started a new bar for the direction and cutoff control.  using his mill I was able to match the length and offset of the original that is seen setting on the new one in the above photo.  I used his DRO to do the math to make a longer one with the same offset and drill the holes.   At home this afternoon I used a hacksaw to remove most of the material and a bench grinder then files and sandpaper to  finish making the new bar. 

Moving the stand and making new bars is an option... but it would be hard as the wheels and springs are in the way of mounting it.  Too much engineering for me.

I will slide the cab back an additional inch.  That gives me 1/2" to overcome.  A new cab, which I kinda wanted anyway because this one sits so high, will get the rest.  Next question, how do people get into the cab?  Do they work on the tender like some locomotives or what?
Not a good plan there... the tender is almost 2" higher than the frame of the loco.  Every time I have seen that design the reverse is true, the engine and firebox is about waste high on the fireman.  I could either ignore it, or I can add a rear deck and make the loco longer. 


Also note how the boiler is now almost completely outside of the cab.  That is one very large cab for such a small locomotive.  I am leaving room to eventually reboiler the locomotive with a longer boiler.  I want to keep the gypsy setup so I cant go forward, or larger in diameter, but I can go rearward, and maybe an odd shape boiler that is taller?  A saddle tank loco might be in line?  Otherwise where is the water?

While we were at it Robb and I figured out that the water supply lines were UST threads not MTP. 

No comments: