I wanted to make sure I hooked up the wires the same way they were before.
When I sharpened my chisels I first made a 25 degree wood block, that warped in the water. so I made a plastic version. That worked better. But sure made a mess.
I took my bar clamps to the O scale club to enable glueing up the modules.
I rerouted the incline on the home layout. It was too tight for standard bachmann On30 cars, this longer route has a large radius and less steep grade.
I took the DWF O scale guys my unfinished boxcar. Most of them model the same era as the car so it was good to hear their input.
cleaning up my desk area I found a couple hard drives from 2005. This one is tempting to use in my book nook. It just looks cool.
Another shot of the DFW layout space. We (they) are doing a major overhaul this year. Replacing four modules of the yard and realigning the tracks on nearby modules, this will enable the portable layout to run three loops. Before we could only run two. There will be a three track yard and an industrial area. This means four trains can be kept busy. Then there is a passing siding for the outer main. That increases train count to five. When the layout is at the shop we plan to have a turntable and engine facility, a passenger yard with station, and a freight storage yard that will not be portable. I am championing the idea of having an interchange with the portable trolley layout that will add five more freight industries and the trolley passenger traffic.
I bought a Lux cutter head for the planer, tired with how short the steel carbide knives last. I run a lot of dirty weathered wood through it. At the same time I replaced the damaged motor drive belt, replaced a broken tensioning spring, and replaced the circuit breaker as it was tripping after 3-5 minutes of light use. Then I replaced the power cord, It was a 14 gauge 6 foot cord. I always ran it plugged into a 50 foot 12 gauge cord. I cut the cord in half and wired it in, now I have a 25 foot 12 gauge cord. I hope this helps. As for the carbide head. I ran some maple through. It is very smooth in the grain direction, but as each cutter is at an angle I can feel waves from side to side. I am sure someone has done a review of the machine and measured the waves, someday if I have some wood and my indicator out I will do the same.
Sunday, I decided to procrastinate and make a second cutting board. I mean chess board. I learned a lot from the first one, but the gaps, sanding gouges, and misalignments made me confident I could do better. I glued it up, and the top side looks great, some gaps on the bottom, but I can rub sawdust and glue into those. I will add sacrificial strips to the edges before I sand so I do not add a slope to the last square.
The inner main of the layout getting plaster leveling for a smooth ride from end to end.
Did you know that the motor of an old hard drive can be used as an encoder? It can also be a stepper motor. I have arduino breakout boards for both functions.
Making a mess of my work table with the plane flattening the first checkers board.
The first board after a coat of oil. It has a more rustic home made feel to it. Not bad, just not high precision. I think I will make a set of checkers to go with this board.













No comments:
Post a Comment