Sunday, July 26, 2020

The SBT Sound System

I annoying the rest of the house by playing lots of loud sounds on the SBT.  My wife asked me what the smell was.  It was the RRE sound box getting too hot.


So after conversation with the engineer at RRE we thought that I was supplying too much voltage.  I found an IR thermometer and did a test.   With the supply voltage at 12 or 24 volts I sat idle or played lots of noise.   24V was fine enough with no sound but it heated up and stayed hot with noise.  The 12 volt was fine in all conditions.  It was less loud, but no garbled sounds either.  

The end result was the decision to supply the RRE with 12v from an external buck converter.  It needed 2amp at max use so I found a 5amp unit.  
 So for one last time for hopefully a long time I stuffed the electronics bay of the SBT. 
 Such a jumbled mess of wires.  When I began I was hoping to have a nice clean looking setup.  I can put a cover over it all if I really cared.  There is a USB to the sabertooth and a micro SD extension cord for the wav trigger.  The only reason to dig to the bottom is now to update wav trigger firmware.
 I also added a new battery to the Odometer.  It does speed too, but unlike before it is not in an external box. 
 I have room for the log book in the loco.  Now that I am turning pens I can make my own custom one to ride along with each one. 
At one point I had the recharging transformer in the SBT but I think it got too hot and blew.  Now it is external.  My goal is to have a second battery set on charge while running.  

So what is next?

September is a meet at White Creek, I plan to bring this and Loco 2 there to run.  
  1. The end of the charger needs stress relief to the keep the wires from breaking.
  2. I only have one transmitter for both locos so I can only run one at a time or MU, I need to bet Robb for the radio.
  3. I need to make the person.  Lets break that into parts... 
    • Feet
    • Legs,
    • Waste,
    • Arms,
    • Head.
  • He will be a lot of work as there are 25 signal wires for the sound system plus the radio antenna running from the right foot up the leg.  Only 13 wires are in use at this time, pondering moving the spedometer output to his backside.
  1. The MU is a loose wire inside.  To use it the cover needs to be held up or I need to notch the cover or drill mounting holes.  I am worried if in use someone sits on the cover pinching the wire.
  2. I need to customize the program
    1.  I can have a few more sound triggers.
    2. The volt and amp meters.
    3.  The onboard speed and direction control.
  3. I also will need custom programming on the handheld.  Horn and bell work, but I can take away the rear headlight and brake trigger and add two sounds.  
  4. I need to make my data logger.  It will be an external box that connects to terminals inside.  Then I can transfer it to another unit.
  5. I need a toolbox to hold the radio and charger, maybe a second set of batteries.

No comments: