Monday, December 23, 2013

Epoxy The Jeffrey

Today I made a jig.

To place the JEFFREY letters in the right spot.
This completes a very important / decorative step.  Well I may drill and pin the letters in place as an added level of security to the epoxy.
I also made the choice to drop the electronics tray to the underside of the pedestal spacer bars.  This drops it below the frame by an inch and and eighth, giving some weight to the middle visually.  I looked at the prototype pictures and can not figure out if the real one had a lower center.  I can see that at least the drivers end had a belly.

No comments: